MULTI-CODE CODE CHANGE INSTRUCTIONS:

TO CHANGE CODE:

1. Press ACCESS LEARN-ACCESS LEARN then EXISTING ACCESS CODE then NEW ACCESS CODE then ACCESS LEARN

SPECIAL NOTES:

1. Batteries should be changed approximately every 6 months in high usage areas. Every year in all other cases.

2. When changing the 9 volt battery, it must be changed within 30 seconds, make sure no lights are on else all programming may be lost.

TROUBLESHOOTING:

1. If you suspect that memory has been lost, remove the battery and press any key for 10 seconds. This will clear all programming and restore all codes to factory default.

2. Low Battery mode: When you enter a code, the light will extinguish with each press of a key. This is your indication that the battery is low and should be replaced immediately.

3. If the correct code is not entered within 20 keystrokes the keypad will lock out all entries for 5 minutes. During this time, all lights will be out and all keypad input will be ignored.

FACTORY DEFAULT:

1. ACCESS CODE: 1234

2. RADIO CODE: 2468-10

PROGRAMMING RADIO CODE:

1. Press RADIO LEARN-RADIO LEARN then EXISTING ACCESS CODE then RADIO CODE then RADIO LEARN.