VISITOR ENTRY: The visitor presses a “#” key
on the system’s keypad. This will call your telephone in the house, at this
time you may communicate with the visitor. If you would like to grant entry and
open the gate, press “9”, this will disconnect you from the visitor and open
the gate.
CALL WAITING: If you are talking on the
phone at the time a visitor call’s you from the gate, you will hear 2 short
tones to signal that someone is attempting to call you. You may press the digit
“2” on your touch tone phone and place your call on hold and at the same time
connect you to the visitor at the gate. You may alternate from the call and the
gate by pressing the digit “2” each time. If you do not want to grant entry to
the gate, you may press the “*” and you will be automatically re-connected to
your call. If you grant entry to the gate by pressing the digit “9”, the gate
will open and you will automatically be re-connected to your call. If you forget that you placed the outside
call or the gate on hold by using call waiting and hang up the phone, the
system will ring your phone 3 times to remind you that you still have a call
waiting.
ENTRY CODES: Unique 4-digit entry codes
may be programmed into the system to allow yourself, relatives, or workers
access without calling the house. When the code is entered in the keypad the
gate will open. (Maximum of 75 different codes)
GATE CONTROL FROM WITHIN THE HOUSE:
From any touch-tone phone in the house you can:
1. Open the gate by pressing “# # 9 1 #”
2. Establish communications by pressing “# # 9 0 #”
If this type of communications are established a 1 minute timer starts and will disconnect the call unless the digit “1” is pressed before the call is terminated, this will extend the time for an additional minute.
3. To lock the gate in the open position press “# # 9 3 #”
4. When you are ready to close the gate again, press “##95#”
(from the home phone)
##89 + ending time (4-digits)# Do NOT Disturb
##8999# Cancel
Do NOT Disturb
##90# Initiate
Communications with the tele-entry
##91# Cycle
the Main Gate (Entry Gate)
##92# Cycle
the Aux Gate (Exit Gate)
##93# Latch
Open the Main Gate (Entry Gate)
##94# Latch
Open the Aux Gate (Exit Gate)
##95# Release
a Main Gate Latch Open Command
##96# Release
a Aux Gate Latch Open Command
##97# Release
BOTH Gates Latch Open Command
##98 + ending time (4-digits)# Latch Open Main Gate until?
##99 + ending time (4-digits)# Latch Open Aux Gate until?
ENTERING PROGRAMMING MODE: Press “*
* * and the programming code” [??????]
EXITING PROGRAMMING MODE: Press
“0 0 #”
SIMPLE ENTRY CODES:
ENTERING AN ENTRY CODE: Press
“03” then “your new 4-digit code” then “#”
example of code 1234: 03+1234+#
ERASING AND ENTRY CODE: Press
“04” then “the code you wish to delete” the “#” example of code 1234:
04+1234+#
· ENTRY CODES
· DOUBLE RING (ALLOWS YOU TO KNOW THE CALL IS FROM THE GATE)
· MAXIMUM RINGS GENERATED BY THE TELE-ENTRY
· MAXIMUM TALK TIME FROM GATE
· CALL WAITING (FROM TELE-ENTRY SYSTEM)
· DO NOT DISTURB
· CALL FORWARDING
· ALARM CALL
· TIME ZONES
· DATE/TIME SETTINGS
· ANSWER RING DETECT
· ENABLE/DISABLE DIRECT COMMANDS
· UNLOCK SCHEDULES (ALLOWS GATE TO OPEN AUTOMATICALLY)