ARMING THE SYSTEM:
1.
Make sure you have a green ready light
2.
Enter your 4-digit code, or press the arming button for Stay or Away for 3
seconds. Make sure the red armed light – lights. (Pressing the Stay button arms
the system without any Motion Detectors; Pressing the Away button arms the
entire system, Perimeter & Interior)
3.
If you are leaving, you must exit within 30 seconds through the front delay
door.
DISARMING THE SYSTEM:
1.
Enter your 4-digit code; make sure the red armed light goes out. If you are
entering the premise through the front door, you will hear a tone from the
keypad to remind you to disarm the system.
GENERAL INSTRUCTIONS:
1.
If you make an error while entering a code, press the pound sign “#”, then
re-enter your code. This will clear the keypad and allow for another entry.
2.
If you set off the Burglary Alarm, the phone will ring, answer and identify
yourself by name & PASSCODE (word) to the operator to cancel the alarm.
3.
If there is any other priority alarm (ie: Fire, Panic, Medical) that was
tripped accidentally, please call us immediately.
4.
If you have a trouble light on, please refer to the owner’s manual for an
explanation of specific trouble conditions or call our office for assistance.
NO GREEN LIGHT:
1.
Press the right arrow key “>” until you see the zone number &
description of the zone that is not allowing the system to give a green light.
Secure that area and you should now have a green light.
ALARM MEMORY:
1.
After an alarm has occurred, there will be an alarm memory message in the
keypad display, the next time you arm the system, this will disappear.