ARMING THE SYSTEM:
1.
Make sure you have a green ready light
2. Enter
your 4-digit code, or press the arming button for Stay or Away for 3 seconds.
Make sure the red armed light – lights. (Pressing the Stay button arms the
system without any Motion Detectors; Pressing the Away button arms the entire
system, Perimeter & Interior)
3.
If you are leaving, you must exit within 30 seconds through a delay door. If
you armed the system by a code or by the Away button, you will hear exit beeps.
DISARMING THE SYSTEM:
1.
Enter your 4-digit code; make sure the red armed light goes out. If you are
entering the premise through a delay door, you will hear a tone from the keypad
to remind you to disarm the system.
GENERAL INSTRUCTIONS:
1.
If you make an error while entering a code, press the pound sign “#”, then
re-enter your code. This will clear the keypad and allow for another entry.
2.
If you set off the Burglary Alarm, the phone will ring, answer and identify
yourself by name & PASSCODE (word) to the operator to cancel the alarm.
3. If
there is any other priority alarm (ie: Fire, Panic, Medical) that was tripped
accidentally, please call us immediately.
4.
If you have a trouble light on, please refer to the owner’s manual for an
explanation of specific trouble conditions or call our office for assistance.
NO GREEN LIGHT:
1.
Look for the zone light that is lit and refer to your zoning information to
determine what area of the protected premise is not secure. Secure that area
and you should now have a green light.
ALARM MEMORY:
1. After
an alarm has occurred, there will be an alarm memory light on the keypad, the
next time you arm the system, this will disappear.